Home FAQs
FAQS

1 .  What are Fluoropolymers ?
2 .  In what forms are Fluoropolymers available commercially?
3 .  Under which Brand Names are Fluoropolymers available worldwide ?
4 .  Material Properties of Fluoropolymers - A Comparison ?
5 .  How to select a Resin for specific use ?
6 .  What is the effect of Fabrication on PTFE, FEP and PFA properties ?
7 .  What is the difference between various fluoropolymer materials?
8 .  What is PTFE? What is INOFLONTM ?
9 .  Can you cement PTFE ?
10 .  How can PTFE stick to another surface?
11 .  What is the difference between etched one side and pressure sensitive tape?
12 .  Why PTFE shapes are etched?
13 .  What is the difference between Virgin and Reprocessed (Mechanical) PTFE?
14 .  Which chemicals is PTFE resistant to?
15 .  What is the highest temperature PTFE can withstand?
16 .  What is the continuous working temperature of PTFE?
17 .  What fillers can be added to Virgin PTFE to change its characteristics?
18 .  What is the melting point of PTFE?
19 .  What is the pressure rating on a specific size of tubing?
20 .  What is the maximum pressure rating of PTFE Bellows?
21 .  What is the alternative low cost similar material to replace PTFE?
22 .  Is PTFE a tough material?
23 .  Can PTFE be directly moulded to intricate shapes?
24 .  What is the maximum flexibility of PTFE bellow that can be achieved?
25 .  Circumferential lines are visible at intervals on Ram Extruded Rod. Are these lines are defects?
26 .  Shrinkage of PTFE Components is found in most of the components. Can it be removed totally or minimised?
27 .  What is designed pressure recommended for Bearing Pads?
28 .  What are the yield service conditions for Piston Rings?
29 .  What is the maximum pressure sustaining capacity of various PTFE Products such as Valve seats, V-Ring Packages, Braided Hoses etc?
30 .  Is Welding of PTFE possible?
31 .  What is the material of construction for higher temperature (more than 200) seats/seals of values, where PTFE is not suitable?
32 .  What is expanded PTFE? How is that in comparison with normal PTFE?
33 .  How to measure the filler content in filled compounds?
34 .  How to assure the quality of PTFE by some simple methods?
35 .  Is regeneration / reuse of PTFE possible?
36 .  PTFE strips & sheets are found to be having warpage / curved surfaces & also bent when made flat. Why is this?
37 .  PTFE Products - Why From Nexgen Fluoropolymers ?
38 .  How to check the quality of etched / chemically treated PTFE shapes?
Home | About Us | Products | Career | Enquiry | Contact Us | FAQs